Information On The Charge Indicator Lamp; Installation Of The Wall Bracket - Silvercrest SAS 7.4 LI D3 Operating Instructions And Safety Instructions

Information on the charge indicator lamp

The charge indicator lamp
The charge indicator light
Lights up red
Flashing green
Flashing alternately green/red
Lights up green

Installation of the wall bracket

DANGER – ELECTRIC SHOCK!
► Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Insert the barrel plug
as shown in the following diagram:
First, feed the cable through the cable routing and then push the barrel plug
into the opening in the wall bracket
barrel plug
2) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
3) Drill two holes about 60 mm apart . Use the wall bracket
holes, to ensure the correct spacing . The drill holes must be suitable for 6 mm
wall plugs .
■ 8 │ GB │ IE │ NI │ CY
supplies the following information:
7
... Meaning
7
on the mains adapter
5
by turning it .
5
the batteries are charging .
the batteries are low and should be
charged soon .
the batteries are completely discharged
and should be charged .
the batteries are fully charged .
the appliance is in operation .
into the wall bracket
4
so that it is firmly in place . Secure the
3
.
3
3
5
:
3
.
4
to mark the
3
SAS 7.4 LI D3