Cisco NCS 4000 Series Manual page 18

Removing the Chassis from the Pallet
1
Required Tools and Equipment
• Number 1 and number 2 Phillips screwdrivers
• 3/8-in. socket wrench or 3/8-in. drive ratchet wrench
Steps
To remove the chassis from the pallet and then transfer the chassis to a moving device, follow these steps:
SUMMARY STEPS
1. Using the Phillips #2 screwdriver, remove the fourteen M4 screws that connect the right support bracket
to the chassis.
2. Using the 3/8-in. socket wrench, remove the 4 hex cap bolts that connect the right support bracket to the
pallet.
3. Set the support bracket aside carefully.
4. Repeat Step 1 through Step 3 for the left support bracket.
Cisco Network Convergence System 4000 Series Unpacking, Moving and Securing Guide
10
28 M4 screws (14 on each side) 2 8 bolts with washers (4 on each side)
Unpacking the Chassis