Extron electronics PowerCage 401 Setup Manual page 2

PowerCage 401 Enclosure • Setup Guide (Continued)
Mounting and Cabling
1.
Turn off or disconnect all equipment power sources.
2.
Mount the PowerCage 401 to a rack using the pre-installed MBD 149 rack ears or use the optional MBU 149 mounting kit for
under-desk mounting (see figure 2).
MBD 149
Mounting Bracket
Figure 2.
Mounting Diagrams
NOTES:
•
For tabletop mounting use the included rubber feet. Up to three units may be stacked together, one on top of the
other.
•
The optional UTM 100 mounting kit may also be used to mount up to 2 units, one under the other.
3.
Connect power to the rear panel IEC connector or connectors (see figure 1,
4.
Attach cables to the LAN and RS-232 connectors, as applicable (see figure 1,
Installing Transmitter and Receiver Boards into the Enclosure
Any combination of up to four transmitter or receiver boards can be installed in the PowerCage enclosure. The quantity and type
of boards vary depending on the configuration for each installation site.
Before installing the boards in the enclosure, refer to the model-specific guide for each PowerCage transmitter and receiver board
you are installing. The guides describe the features of each board and how to set up and cable it.
NOTE: The power supplies and boards are hot-swappable; they can be installed or removed without turning off or
disconnecting the power to the PowerCage 401 enclosure.
CAUTIONS:
ATTENTIONS :
•
Use ESD precautions when installing a board to avoid damaging it. Keep the board in the anti-static bag until it is
needed.
•
Prenez les précautions ESD lorsque vous installez une carte afin d'éviter de l'endommager. Gardez la carte dans le
sachet dépoussiérant jusqu'à ce que vous en ayez besoin.
•
Use proper grounding techniques during installation.
•
Utilisez des techniques de mise à la terre correctes pendant l'installation.
2
P LY
U P
R S
W E
P O
S T
JU
A D
U
M EN
1
E 40
A G
T R C
N EX
W E
P O
SE T
RE
n
tr o
E x
NF IG
CO
P LY
U P
R S
W E
P O
P O
MBU 149
Mounting Bracket
PowerCage 401
POWER SUPPLY
MBU 149
Mounting Bracket
A and
G and
P LY
U P
R S
W E
P O
S T
A D JU
U
M EN
1
E 40
A G
T R C
N EX W E
P O
T
SE
RE
tr o n
E x
IG
NF
CO
P LY
U P
R S
W E
POWER SUPPLY
ADJUST
MENU
NEXT
RESET
CONFIG
Extron
POWERCAGE 401
B on page 1).
H ).