Mounting the controller
1. Using a drill bit of 3/ 16 inch diameter,
drill a hole to a depth of 1 inch
(25 mm).
2. Insert plastic anchor so it is flush
with the surface of the wall.
3. Screw 1 inch screw into anchor
leaving the head protruding about
1/8 inch (4 mm).
①
Rear cable entry point
(remove with knife)
②
Conduit cable entry point
(remove with knife)
③
Wall mounting screw
④
Power indicator
⑤
Expansion module
cable entry
⑥
Go to previous screen
⑦
Go to home screen
2
4. Slide the controller case over the
screw head.
5. Mark second mounting point (see
in diagram), remove controller, drill
hole, insert plastic anchor, slide
controller case over first screw head
and screw into place.
④
①
③
⑤
②
③
⑥
⑦