Connecting To A Wi-Fi Network; Using The Wizard - Hunter Hydrawise HC Quick Start Manual

CONNECTING TO A WI-FI NETWORK

When your controller is first powered on it will run a short wizard to connect your
controller to your wireless router.
If you're not using the initial startup wizard then go to the Viewing Wireless Settings
section to change your wireless settings at hunter.direct/hchelp.

Using the Wizard

1. Select your wireless network from the list shown on the controller display
and press the Confirm button on screen.
Note: If your network is not listed then check that the
unit is within wireless range.
2. Enter your wireless password and press the OK button on keyboard.
Note: Make sure you press the OK button after you've
entered your password. Pressing the Home
buttons will not save your changes.
When connecting to your wireless network, the Wi-Fi Icon
controller screen will flash. Connecting takes about 30 seconds and when successfully
connected the Wi-Fi Icon will stop flashing and stay on.
or Back
at the bottom right of the
3