Remove The Solid-State Drive - Lenovo IdeaPad 5 Hardware Maintenance Manual

Step 2. Remove two screws and then remove the hard disk drive bracket.
Figure 37. Remove the hard disk drive bracket
Screw specifications
M2 x L5
Go to
https://support.lenovo.com/partslookup
replacement part:
Hard disk drive cable
Hard disk drive bracket

Remove the solid-state drive

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 46
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and then remove the solid-state drive by pulling it away from the slot.
Figure 38. Remove the solid-state drive
Screw specifications
M2 x L3
48
Hardware Maintenance Manual
Number of screws
2
to look up the Lenovo part numbers of the following
Number of screws
1