Remove The Lcd Module - Lenovo IdeaPad 5 Hardware Maintenance Manual

Figure 21. Remove the system board
Go to https://support.lenovo.com/partslookup
replacement part:
System board

Remove the LCD module

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Detach the antennas cable and disconnect the LCD cable from the system board. Release the
antennas cable from the cable guide.
Figure 22. Disconnect the cables
Step 3. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove five screws.
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
39