Remove The Solid-State Drive - Lenovo Legion 5i Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
replacement part:
Memory module

Remove the solid-state drive

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board, remove one screw, and remove the
solid-state drive by pulling it away from the slot.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 9. Disconnect the battery pack cable, remove one screw, and remove the solid-state drive
Screw specifications
M2 × L3
Note: The product supports up to two solid-state drives. Remove both if needed.
Notes: For LCD panel with the factory color calibration feature, do the following to install new color
profiles:
1. Go to https://pcsupport.lenovo.com/us/en/downloads/DS543953
software. Double-click the EXE file and follow the on-screen instructions to finish the
installation.
2. X-RiteColorAssistant.exe will auto run. Click Restore Profile button from prompted window to
restore the profile from Lenovo cloud.
Go to https://support.lenovo.com/partslookup
replacement part:
Solid-state drive
to look up the Lenovo part numbers of the following
Number of screws
1
to look up the Lenovo part numbers of the following
Torque
1.85 ± 0.15 kgf-cm
to download the installation
.
Chapter 4 Removing a FRU or CRU
33