Remove The Solid-State Drive Bracket; Remove The Wi-Fi Card; Remove The Solid-State Drive Module - Lenovo IdeaPad 5 Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
replacement part:
Solid-state drive

Remove the solid-state drive bracket

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 46
"Remove the solid-state drive" on page 48
Step 1. Remove one screw and then remove the solid-state drive bracket.
Figure 39. Remove the solid-state drive bracket
Screw specifications
M2 x L3
Go to
https://support.lenovo.com/partslookup
replacement part:
Solid-state drive bracket

Remove the Wi-Fi card

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 46
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Detach the main and auxiliary antenna cable connectors. Remove one screw and then remove the
wireless module by pulling it away from the slot.
to look up the Lenovo part numbers of the following
Number of screws
1
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
49