Advertisement
08
3) Jump starter * Smart Jumper Clamp(EC5 connector) is optional.
a. Plug one end with EC5 connector (Optional) of the battery clamps into the jumping port of your power
station.
b. Connect the positive and negative polarities of the battery clamps to the positive and the negative
polarities of car battery (Red to +, black to -).
c. Turn the car key to start it up.
d. Disconnect the clamps with battery and the jumping port of your power station.
NOTE:
Make sure the gas engine displacement of the vehicle is less than 4L.
1. Make sure the battery power is over 60%
2. Make sure the battery clamps is not broken.
3. Before starting, make sure the red and black clips are clamped tightly to the battery poles of your
car, keep the two clips with enough safety distance, to prevent the two from falling off or collision
because of the engine vibration after car starting.
4. It is strictly prohibited to connect the red and black clip directly, otherwise it may cause accidents.
5. Please keep away from the engine when starting the car to avoid any physical injury that may
caused by car engine running.
6. Please remove the product from battery within 30 seconds after engine started, otherwise it might
cause damage to the portable power supply or even cause accident
7. People who are not familiar with this product(especially children) is strictly prohibited to use this
function.
8. Please remove all personal jewelry, such as rings, bracelets, necklaces, and watches before jump
starting.
Car battery
HPS-300/600/1100/1600
Hide quick links:
Advertisement
