H3C S1200 Series Getting Started Manual page 13

Figure 7 Wall-mounting anchor kit
To install the switch on a concrete wall:
Drill two holes at the same height, as shown in
1.
Figure 8 Hole spacing
The hole depth and diameter depend on the wall anchors and screws you use. Make sure you can
push the anchors to their full depth in the holes.
Installation hole spacing varies by switch model, as shown in
Table 4 Installation hole spacing requirements
Product
S1205
S1205-PWR
S1208
S1208-PWR
S1216
Insert one wall anchor into each hole until the anchors are flush with the wall surface.
2.
Drive one screw into each wall anchor, and tighten the screws just enough to keep it secure in
3.
the wall anchor.
Leave a minimum clearance of 1.5 mm (0.06 in) between the base of the screw head and the
wall anchor so the switch can hang on the screws securely.
Figure 9 Driving a screw into a wall anchor
Figure 8.
Installation hole spacing
74 mm (2.91 in)
90 mm (3.54 in)
90 mm (3.54 in)
90 mm (3.54 in)
160 mm (6.30 in)
7
Table 4.