Table of Contents
Advertisement
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-
tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When
these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific
hazard symbols and warnings not covered in this section may appear throughout the body of this manual where
applicable.
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and other body parts.
•
Keep clear of moving parts.
•
Do not operate equipment with protective guards or covers removed.
•
Pressurized equipment can start without warning. Before checking, moving, or servicing equip-
ment, Relieve Pressure and disconnect all power sources.
ELECTRIC SHOCK HAZARD
This equipment must be
electric shock.
•
Turn off and disconnect power before servicing equipment.
•
Connect only to grounded electrical outlets.
•
Ensure ground prongs are intact.
•
Do not expose to rain. Store indoors.
•
All electrical wiring must be done by a qualified electrician and comply with all local codes and
regulations.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
•
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•
Do not exceed the maximum working pressure or temperature rating of the lowest rated system
component.
•
Use fluids and solvents that are compatible with equipment wetted parts. Read fluid and solvent
manufacturer's warnings. For complete information about your material, request Safety Data
Sheet (SDS) from distributor or retailer.
•
Turn off all equipment and Relieve Pressure when equipment is not in use.
•
Check equipment daily. Repair or replace worn or damaged parts immediately with genuine man-
ufacturer's replacement parts only.
•
Do not alter or modify equipment. Alterations or modifications may void agency approvals and cre-
ate safety hazards.
•
Make sure all equipment is rated and approved for the environment in which you are using it.
•
Use equipment only for its intended purpose. Call your distributor for information.
•
Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
•
Do not kink or over bend hoses or use hoses to pull equipment.
•
Keep children and animals away from work area.
•
Comply with all applicable safety regulations.
WARNING
WARNING
WARNING
grounded.
Improper grounding, setup, or usage of the system can cause
Page 3
Warnings
Advertisement
Table of Contents
