Chapter 6 Specifications - THORLABS ELL6 Operating Manual

ELL6K Dual Position Optics Slider Kit
Chapter 6 Specifications
Switching Time
Travel
Endstop Repeatability
Maximum Load (Vertically Mounted)
Minimum Lifetime
Rated Voltage
Typical Current Consumption, During Movement
Typical Current Consumption, During Standby
Typical Current Consumption, During Frequency
Search
d
Bus
e
Speed
Data Length
Protocol Data Format
Module Address and Command Format
Ribbon Cable Length (Supplied)
Ribbon Cable Length (Maximum)
Optic Thread Type
Dimensions of the Slider (Mount Centered)
Dimensions of the Slider (Mount at Full Extension)
Dimensions of the Control Board
Weight: Slider unit only, (no cables or handset).
Weight: Handset
Notes
.Low power infrared photo-sensor technology aligns the slider at each position.
a
Vertically Mounted so that Movement is Side-to-Side and not Up-and-Down
b.
.Lifetime is measured in terms of distance traveled by the optics mount.
c
.Additional Power Supply May Be Required
d
Use two 10 kΩ pull-up resistors in multi-drop mode for RX/TX.
e.
1 Stop Bit, No Parity
f.
Page 16
General Specifications
a
c
f
b
100 km (3.3 Million Operations)
Multi-Drop 3.3V/5V TTL RS232
64.0 mm x 77.7 mm x 10.3 mm
79.0 mm x 77.7 mm x 10.3 mm
32 mm x 65 mm x 12.5 mm
Chapter 6: Specifications
Unloaded: 180 to 270 ms
100g Load: <600 ms
31 mm (1.22")
<100 µm (30 µm Typical)
150 g (5.29 oz)
4.5 to 5.5 V
<600 mA
38 mA
1.2 A
9600 baud/s
8 bit
ASCII HEX
Mnemonic Character
250 mm
3 m
SM1
(2.52" x 3.06" x 0.41")
(3.11" x 3.06" x 0.41")
(1.26" x 2.56" x 0.49")
44 g (1.55 oz)
10.3 g (0.36 oz)
DTN000414-D02