Nexcom TPPC 2401 User Manual page 58

Chapter 4: BIOS Setup
CPU Configuration
This section is used to configure the CPU.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced
CPU Configuration
Socket 0 CPU Information

CPU Speed 1300 MHz
64-bit Supported
CPU Power Management

Active Processor Cores [Disabled]
Intel Virtualization Technology [Disabled]
VT-d [Disabled]
Version 2.18.1263. Copyright (C) 2019 American Megatrends, Inc.
Socket 0 CPU Information
The submenu that displays information on the CPU installed on socket 0.
CPU Power Management
The submenu for configuring CPU power management settings.
Active Processors Cores
Select the number of cores to enable in each processor package.
Intel Virtualization Technology
®
Enables or disables Intel Virtualization technology.
VT-d
Enables or disables the VT-d function.
Copyright © 2019 NEXCOM International Co., Ltd. All Rights Reserved.
USB Configuration
This section is used to configure the USB.
Socket specific CPU Information
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
XHCI Hand-off
This is a workaround for OSs that does not support XHCI hand-off. The
XHCI ownership change should be claimed by the XHCI driver respectively.
USB Mass Storage Driver Support
Enables or disables USB mass storage driver support.
USB transfer time-out
The time-out value for control, bulk, and Interrupt transfers.
43
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced
USB Configuration
17
USB Module Version
USB Controllers:
1 XHCI
USB Devices:
1 Keyboard, 1 Mouse
XHCI Hand-off [Enabled]
USB Mass Storage Driver Support [Enabled]
USB hardware delays and time-outs:
USB transfer time-out [20 sec]
Device reset time-out [20 sec]
Device power-up delay [Auto]
Version 2.18.1263. Copyright (C) 2019 American Megatrends, Inc.
This is a workaround for OSes
without XHCI hand-off support.
The XHCI ownership change
should be claimed by XHCI
driver.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
TPPC 2401/2701/3201 User Manual