Starting The Engine - Yamaha NMAX 155 Owner's Manual

Operation and important riding points

Starting the engine

The ignition circuit cut-off system will
enable starting when the sidestand is
be up.
To start the engine
1. Turn the main switch on.
2. Confirm the indicator and warning
light(s) come on for a few sec-
onds, and the go off. (See page
6-1.)
TIP
 Do not start the engine if the en-
gine trouble warning light remains
on.
8
 The ABS warning light should
come on and stay on until the ve-
hicle reaches a speed of 10 km/h
(6 mi/h).
NOTICE
If a warning or indicator light does
not work as described above, have a
Yamaha dealer check the vehicle.
3. Close the throttle completely.
4. While applying the front or rear
brake, push the start switch.
5. Release the start switch when the
EAU86740
engine starts, or after 5 seconds.
Wait 10 seconds before pressing
the switch again to allow battery
voltage to restore.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA24110
NOTICE
Do not ride through deep water, oth-
erwise the engine may be damaged.
ECA11043
Avoid puddles because they may be
deeper than expected.
8-2
EAUN0073
ECAN0072