Front Brake Lever - Yamaha NMAX 155 Owner's Manual

Instrument and control functions
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Start switch " "
With the sidestand up, push this switch
while applying the front or rear brake to
6
crank the engine with the starter. See
page 8-2 for starting instructions prior
to starting the engine.
Hazard switch " "
With the main switch in the "ON" posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
EAU12501
tery may discharge.
Menu switch "MENU"
EAU12722
This switch is used to perform selec-
tions in the setting mode display of the
multi-function meter unit.
See Multi-function meter unit on page
6-2 for detailed information.
Stop and Start System
EAU79500
switch " / " A
A
To turn on the Stop and Start System,
set the switch to " ". To turn off the
Stop and Start System, set this switch
A
to " ".
ECA10062

Front brake lever

EAU59011
1. Front brake lever
The front brake lever is located on the
right side of the handlebar. To apply
the front brake, pull this lever toward
EAU76391
the throttle grip.
A
6-9
EAU12902
1