Nice RUN1800 Instructions And Warnings For Installation And Use page 44

7.3.5) RUN in "Slave" mode
When correctly programmed and connected, RUN can function in
"Slave" mode; this type of function is used when 2 opposite gates
need to be automated with the synchronised movement of the two
leaves. In this mode RUN works as Master commanding the move-
ment, while the second RUN acts as Slave, following the commands
transmitted by the Master (all RUN are Masters when leaving the
factory).
To configure RUN as a Slave level one "Slave mode" must be acti-
vated (see table 7).
The connection between RUN Master and RUN Slave is made via
BlueBus.
In this case the polarity of the connections between the
two RUN must be observed as illustrated in fig. 26 (the other
devices remain with no polarity).
Follow the operations below to install 2 RUN in the Master and Slave
mode:
• Install the 2 motors as indicated in fig. 25. It is not important which
motor is to function as Slave or Master; when choosing, one must
consider the convenience of the connections and the fact that the
Step-by-Step command of the Slave only allows the Slave leaf to
be opened fully.
LUCYB
S.C.A.
26
When connecting 2 RUN in the Master-Slave mode, strictly observe the following:
• All devices must be connected to the RUN Master (as in fig. 26) including the radio receiver.
• All programming performed on RUN Slave is ignored (that on RUN Master overrides the others) except for those mentioned in table 14.
44
OPEN CLOSE
MOSE
MOFB
25
• Connect the 2 motors as shown in fig. 26.
• Select the opening direction of the 2 motors as shown in fig. 25
(see also paragraph "4.1 Choosing the direction").
• Supply power to the 2 motors.
• Program the "Slave mode" on the RUN Slave (see table 7).
• Perform the device self-learning on the RUN Slave (see paragraph
"4.3 Self-learning devices").
• Perform the device self-learning on the RUN Master (see para-
graph "4.3 Self-learning devices").
• Perform the self-learning of the leaf length on the RUN Master (see
paragraph "4.4 Leaf length self-learning").
LUCYB
S.C.A.
STOP PP