Stopping - Husqvarna FS7000 DL Operator's Manual

• Lower the blade by pressing the Raise/lower switch on the
Speed control lever until the diamond blade is at the
desired cutting depth. For more information see section
"Blade depth stop".
CAUTION! When lowering the blade into a partial cut, align
the blade exactly with the cut to prevent damage to the
blade.
• Move the saw forward slowly by pushing on the Speed
control lever. Listen to the sound of the engine. If the
engine starts to slow down compensate by pulling Speed
control lever backwards to decrease feeding and prevent
stalling the blade. Make sure the front guide, rear guide
and diamond blade stays on the line.
To adjust tracking, see the "Straight line sawing" section.

Stopping

WARNING! Always keep all parts of your
!
body away from blade and all other moving
parts.
Stop the cutting
• Put Speed control lever into the STOP position.
28 –
English
STARTING AND STOPPING
• Raise the diamond blade out of the cut by pressing the
Raise/lower switch on the control lever upward until the
diamond blade clears the surfaces.
Stop the engine
1 Turn the Engine throttle knob to the low idle position.
2 Turn off the Water valve.
3 Let the engine run at idle for a few minutes before shutting
off. Do this within the cutting area and do not leave the
machine unsupervised.
4 Stop the engine by turning the Engine start switch to the
STOP position.
4
3
idle rpm
2
1