Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna MS360 Operator's Manual

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using
the machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are
in the working area, otherwise there is a
risk of serious personal injury.
Prevent unintentional starting of the
motor. Ensure the power switch is in the
OFF-position before connecting the
machine to a power source.
• Check that the machine is assembled correctly and do
not show any signs of damage. See instructions in the
section "Assembling and adjustments".
• Perform daily maintenance. See instructions in the
section "Maintenance".
• Check that the blade is not in contact with the
conveyor cart so that it can not damage the cutting
slot.
• Adjust the side table.
• When the machine has been transported to a suitable
site, it should be connected to an electric outlet.
• Loosen the locking knob for the conveyor cart.

Starting

• Push the insert (1) down to release the lock and flip
the power switch (2) up to start the machine.
1
• The water pump starts automatically when the
machine is started.
• Wait a few seconds for the water slots in the cart to be
filled with water before starting to cut.

STARTING AND STOPPING

2

Stopping

• Flip the power switch down to stop the machine. Make
sure that the cutting blade can rotate freely until it is
completely stopped.
–
English 19