Error Messages - Husqvarna FS7000 DL Operator's Manual

Error messages

Fault Message on
DTC description
Code the display
No CAN
U100087 I/O Controller
communication
Software download
U100088 I/O Controller
failed
Program memory
P060745 IOC MPU
failure
General memory
P060742 IOC MPU
failure
Circuit short to
C1F0612 Crank signal
battery
Blade depth Circuit short to
C1E0111
sensor signal ground
Blade depth Circuit short to
C1E0112
sensor signal battery
Circuit short to
C1D0115 Starter
battery or open
Circuit short to
C1D0111 Starter
ground
Power supply
Circuit short to
C1D0711 external
ground
device
Power supply
Circuit short to
C1D0712 external
battery
device
Circuit short to
C1D0815 AUX1
battery or open
Circuit short to
C1D0811 AUX1
ground
Circuit short to
C1D0215 AUX2
battery or open
Circuit short to
C1D0211 AUX2
ground
Circuit short to
C1D0315 Blade clutch
battery or open
Circuit short to
C1D0311 Blade clutch
ground
42 –
English
TROUBLESHOOTING
Indication on the
Possible action
machine
Check damage to connectors X1, X4, X14 and chassis
harness. If found, repair and restart system, reset fault
code.
If problem still exists, contact your service agent for further
Engine can not be
information.
started. No
machine function Contact your service agent.
can be controlled.
Contact your service agent for further information.
Check damage to key switch, key switch connectors X30,
Engine can not be
X32 and harness. If found, repair and restart system,
started.
reset fault code.
Disconnect sensor and reset fault code. If fault code no
longer exists check sensor and sensor harness.
Blade depth can not
Check damage to X13 and X14 connectors and harness
be displayed. Blade
to sensors. If found, repair and restart system, reset fault
depth stop can not
codes.
be used.
Contact your service agent for further information.
Engine starter can Check damage to X14 and X1 connector and harness. If
not be controlled. found, repair and restart system, reset fault code.
Cutting can not
continue.
It problem still exists, contact your service agent for further
Engine can not be information.
started.
Check cables to:
Cutting can not
Blade depth sensor and sensor itself
continue.
E-track position sensor and sensor itself
Neutral start switch and switch itself
May not be able to
Lower/raise switch and switch itself
read sensor values.
Water safety switch and switch itself
Check K4 relay in relay/fuse box.
Check damage to X14 connector, harness to relay/fuse
AUX1 can not be
box and relay/fuse box connector. If found, repair and
controlled by the
restart system, reset fault code.
HMI.
If problem still exists, contact your service agent for further
information.
Check K5 relay in relay/fuse box.
AUX2 (5th wheel) Check damage to X14 connector, harness to relay/fuse
can not be box and relay/fuse box connector. If found, repair and
controlled by the restart system, reset fault code.
HMI.
If problem still exists, contact your service agent for further
information.
Check K7 in relay/fuse box.
Blade clutch can
not be controlled by Check damage to X14 connector, harness to relay/fuse
the HMI. Blade box and relay/fuse box connector. If found, repair and
might be engaged restart system, reset fault code.
or disengaged the
If problem still exists, contact your service agent for further
whole time.
information.