Charging The Batteries; Battery Installation - Topcom Twintalker 9500 Airsoft Edition Manual

TT 9500 Airsoft Edition.book Page 5 Monday, January 14, 2013 4:28 PM
Twintalker 9500 (RC-6406) Airsoft Edition
9 Getting started
9.1 Installing/Removing the Belt
Clip
1. To remove the belt clip from the unit,
push the belt clip (B) towards the
antenna, while pulling the clip tab (A).
2. When re-installing the belt clip, a click
indicates the belt clip is locked into
position
9.2

Battery Installation

1. Remove the belt clip (see chapter "9.1 Installing/Removing the
Belt Clip")
2. Lift the battery door by gently pushing the door clip (C) using your
finger nail.
3. Install the NiMh batteries. Make sure that the polarity of the NiMh
batteries is correct.
4. Close the battery door.
5. Re-install the belt clip

10 Charging the batteries

1. Connect the connector of the
power adapter directly to the
charger connection of the
3
PMR.
It will take about 8 to 10 hours to fully
charge the batteries
Do not press the -Button
PTT
they are charging !
Do not short-circuit the batteries or dispose in fire.
Remove the batteries if this device is not going to be
used for a long period.
Do not charge non rechargeable batteries like Alkaline
batteries in the charger. This might damage the PMR's
and charger unit.
11 Description
See folded cover page - illustration 1
1. ON/OFF Volume knob
2. LCD display
3. Charger connection
4. Headset connection
5. TX LED ( on when transmitting)
6. Call button
7. Menu button
– Enter the menu settings
8. Microphone
5
of the PMR's while
12