Getting Started; Charging Batteries - Topcom Twintalker 9100 User Manual

Topcom Twintalker 9100
8

Getting started

8.1 Removing/Installing the Belt Clip
1. To remove the clip from the unit, push the belt
clip (B) towards the antenna, while pulling the
clip tab (A).
2. When re-installing the belt clip, a click indicates
the belt clip is locked into position.
8.2 Battery Installation
1. Remove the belt clip (§ 8.1).
2. Open the locking latch (C) and slide off the
battery cover.
3. Install the rechargeable battery pack following
the polarity as shown. Ensure that the metal
contacts on the side (D) are facing outwards
from the radio to connect on the battery door.
4. Re-install the Battery Cover and Belt Clip (§
8.1).
9

Charging batteries

When battery packs are installed, the desktop charger provides drop-in charging
conveniency
1. Put the desktop charger on a flat
surface.
2. Plug one end of the supplied
adapter into the electric socket
and the other end into the
connector on the backside of the
desktop charger.
3. Put the radio in the charger as
indicated.
4. The charging LED will turn on if
it's properly inserted and
charging.
It will take about 8 to 10 hours to fully charge the batteries
Do not short-circuit & dispose of in fire. Remove the batteries if this
device is not going to be used for a long period.
6
A
B
C
D
Topcom Twintalker 9100