Call Tones; Key-Tone On/Off; Dual Channel Monitor Function - Topcom Twintalker 9500 Airsoft Edition Manual

TT 9500 Airsoft Edition.book Page 9 Monday, January 14, 2013 4:28 PM
Twintalker 9500 (RC-6406) Airsoft Edition
13.10.3 Scanning for a DCS code
• Press the
"SCAN" and "DCS 00" flashes on the
display for the selected radio channel.
• Press the
button
10
Once there is a transmission on the channel, the DCS code (if used) will
be detected and displayed.
If you press the button
PTT
found DCS code, the PMR will go back in stand-by mode
on the channel with the DCS code.

13.11 Call Tones

A call tone alerts others that you want to start talking.
13.11.1 Setting the Call Tone
The Twintalker 9500 (RC-6406) has 15 call tones.
• Press the
"C" is displayed and the current call tone
is flashing.
• Press the
button
10
Tone.
• Press the
PTT
and return to stand-by mode.
13.11.2 Sending a call Tone
6
Press the button briefly. The call tone will be transmitted on the
set channel.
13.11.3 Call tone reception type
• Press the -button 7 nine times.
• Press the -button or -button
11
reception type.
1.
2.
-button 7 seven times :
3.
-button or the -
11
to start the DCS scan.
13.12 Roger Beep On/Off
After the
to confirm that you have stopped talking.
while listening to a
12

13.13 Key-Tone On/Off

- button 7 eight times,
When a button is pressed, the unit will beep briefly.
- button or the -
11
to change to another Call
- button to confirm
12

13.14 Dual Channel Monitor function

In stand-by, the PMR is set on one channel with CTCSS/DCS code. The
PMR will only receive signals transmitted on that channel with the
CTCSS/DCS code.
10 to select the call tone
Tone only
Tone + vibration
Vibration only
Press the -button to confirm and return to stand-by mode.
12
PTT
-button is released, the unit will send out a roger beep
PTT 12
To set the Roger Beep.
•Press the - button
displayed.
•Press button
11
button 10 to disable the Roger-Beep (OFF).
•Press the - button
PTT
selection and return to the standby mode.
To set the key-tone.
7
•Press button
displayed.
•Press button
11
button to disable the Key Tones (OFF).
10
•Press the - button
PTT
selection and return to the standby mode.
9
7 ten times. 'rO' will be
to enable (ON) or
to confirm your
12
eleven times. 'tO' will be
to enable (ON) or
to confirm your
12