Advertisement
7. Connect the provided power
!-harness according to the diagram
displayed under the Test Connection
on page 6 or see illustration on the
right. Connect the female and male
12V power connectors first then
route the type-c connector to the
designated slot created during the
preparation steps on page 6.
8. Routing the type-c connector through
the pocket/Qi-bezel:
A. Pass the Type-C connector
through the hole created durring
preparation on the pocket.
B. Second, pass the connector
through the TAQ04 bezel.
C. Place direct-Qi bezel into the
pocket location.
9. Routing the type-c connector to the
MQUSM
Qi module:
A. Connect the Type-C connector to
the MQUSM.
B. Place the module onto Qi bezel
C. Re-install the pocket into place
using screws removed durring
disassembly.
Notes:
• Hide any excess wiring under the panels/
pocket before reassembling.
• Use the provided two-sided adhesives to
secure the panel/module from moving.
10.
Lastly, reassemble everything in
reverse order, then place your Qi
enabled device onto the TAQ04
assembly to charge your device.
Refer to LED Charging Status for
charging details (page 6).
"Phone NOT included
VEHICLE ASSEMBLY
...- 12V H ar ne ss G ro u n d
.....
�
(pf��
.....
""" 12V Harness Power
I::\
�
8
Black to Black
Red to Red
To Q i M od u le
•
(MQUSM)
Advertisement
