Vaisala MD30 Setup Manual page 6

Setup Guide
Cabling Bluetooth module enclosure
1. Select a suitable location for the Bluetooth module enclosure in the vehicle cabin.
2. Open the enclosure by removing the 4 screws and the lid.
3. Route the extension cable from the mobile sensor towards the Bluetooth module enclosure.
4. Connect the extension cable wires in the Bluetooth module enclosure as shown in the following
figure.
Vehicle power
outlet
12 ... 32 VDC
Connect last!
Splitter
(optional)
5. Route the power cable from the Bluetooth module enclosure next to the vehicle power outlet and
connect it.
If you use a splitter, connect that first. You can use the existing plug or unscrew the plug, strip the
cable, and connect the wires.
6. Attach the lid to the enclosure. Tighten the cable glands.
7. Attach the enclosure to a suitable location in the vehicle cabin using adhesive tape or other
fasteners.
8. Secure the MD30 cable and connector to the vehicle with cable ties.
6
Follow the instructions that are relevant to your version of the Bluetooth module enclosure.
RoadAI mobile device
Bluetooth
module enclosure
Power cable
Extension cable
8 m (26 ft)
Global version (BM10)
1 2 1 2 3 4
North America version
(BM10-NA)
M212169EN-D
5 6 7