Table of Contents
Advertisement
Excessive water remaining above the filter plate, after the rinse cycle (this can be displayed as
Check for a kinked drain hose, blocked waste connection, highloop not properly installed,
z
z
drain hose not routed correctly or spray arms not in place.
No water supply (this is displayed as
Check water is connected and turned on.
z
z
The dishwasher is beeping continuously
There is a fault.
z
z
See section 'How to attend to a fault' in the User Guide for further information.
z
z
Water around water supply and drainage connections
Check connections, existing plumbing and hoses for leaks.
z
z
Check rubber washer and hose clamp are correctly fitted.
z
z
If appliance is tipping
The appliance is not secure under the benchtop.
z
z
Ensure the appliance is level and placed between cabinetry.
z
z
Adjust the feet so that the dishwasher sits securely under the benchtop.
z
z
If front panel is misaligned
Check and re-level appliance.
z
z
Check the cabinetry is square.
z
z
Check and adjust the front panel alignment if necessary.
z
z
Door doesn't close properly
Ensure nothing is obstructing the door from closing properly.
z
z
Check that the customized panel is a suitable length to fully close and that there is enough clearance for the door,
z
z
so that the door's movement is not obstructed by the floor or surrounding cabinetry.
If a problem occurs, see 'Troubleshooting' page of the User guide.
If after checking these points you still need assistance, refer to the Service & Warranty book for warranty details
and your nearest Fisher & Paykel trained and supported service technician, or contact us through our website fisherpaykel.com.
20
@2
A10
fault)
TROUBLESHOOTING
A20
fault)
Hide quick links:
Advertisement
Table of Contents
