Table of Contents
Advertisement
IMPORTANT!
Ensure to flush the water line into a bucket before connecting to the water inlet valve.
Prepare water supply connection
gasket
1
Connect an elbow (90°) to the water inlet valve.
Ensure a rubber gasket is placed between the threads of the elbow
z
z
and water supply valve. Do not overtighten the elbow.
Ensure the end of the elbow is pointing to the rear of the dishwasher.
z
z
hot water line
Insert the hot water line (copper pipe or flexible braided hose) through
2
the water supply hole from the side of the cabinetry. (Refer to 'Cavity
preparation, page 9 for more details).
Be careful not to damage the water line while inserting through the hole.
z
z
3
Install a hand shut-off valve to the water line in a location that is easily
accessible in the adjacent cabinetry (eg under the sink).
inlet valve
elbow (90°)
hand shut-off valve
!6
HARD PLUMBING
Connect hot water line to inlet valve
If using a flexible braided hose:
1
Screw the nut of the hose to the thread of the elbow.
Tighten with an adjustable wrench.
If using a a copper pipe:
2
Slide the compression nut and ferrule towards the end of the pipe.
Insert the end of the pipe into the elbow and screw the compression
nut to the thread of the elbow.
inlet valve
braided hose
elbow (90°)
inlet valve
copper pipe
elbow (90°)
elbow (90°)
15
Hide quick links:
Advertisement
Table of Contents
