Fisher & Paykel DW24U6I1 Installation Manual page 16

IMPORTANT!
Ensure the power cord and connections comply with the National Electrical Code, Section 422 and/or local codes
z z
and ordinances. Maximum power cord length is 6 feet. A Power Cord Kit is available for purchase from an authorized
Fisher & Paykel appliances dealer.
Check the house wiring. If it is not 2-wire with ground, a ground must be provided by the installer.
z z
If the house wiring is aluminum, use UL-Listed anti-oxidant compound and aluminum-to-copper connectors.
Remove the junction box cover
1
Unclip and remove the junction box cover to access
the appliance electronics. Do not remove the screw
holding the junction box bracket in place.
14
!5 ELECTRICAL CONNECTION
Black wire White wire UL listed wire nuts
Green wire Grounding screw
(grounded)
Connect wires
2
Install the strain relief into the junction box bracket,
and secure the house wiring or the power cord and
tighten. Thread the wires through the hole in the junction
box bracket and connect the incoming ground to green,
white to white and black to black.
Power cord/
house wiring
Strain relief
Refit the junction box cover
3
Refit the junction box cover ensuring no wires are
pinched beneath the cover. Ensure the power cord
is routed under the appliance.