Table of Contents
Advertisement
IMPORTANT!
Ensure the appliance is leveled for proper dish rack, wash performance and door operation.
To verify dishwasher is leveled, open and close the door and pull the dish racks half way out.
The door should fit in the tub opening without hitting the sides. If the racks roll on their own, or
the door hits the side of tub, re-level.
Remove toe kick and mounting plate
1
To access the rear leg adjustment pin, you will need to remove the four screws
holding the toe kick and mounting plate. Set screws aside for re-installation.
IMPORTANT!
Ensure top of door is aligned flush with surrounding cabinetry.
z
z
Use floor protection before sliding the appliance into the cabinetry.
z
z
Remove the protection once the appliance is positioned in
the cabinetry.
As you push the appliance in, pull through hoses and cord, ensure
they don't get kinked or twisted.
Note: If using an infill bracket for cabinets with cavity height of 35.5"
or above, refer to 'Attach infill bracket' (page 10) for more details.
!3
LEVEL DISHWASHER
!4
ALIGN APPLIANCE IN CABINETRY
0-1/4
(0-6.4mm)
Adjust leg height
2
Adjust the rear foot via the back leg adjustment pin using an Allen Key.
The front feet can be adjusted using an adjustable wrench.
Center appliance
floor protection
13
Hide quick links:
Advertisement
Table of Contents
