Table of Contents
Advertisement
(between panel and screw head)
Fix slider bracket and screws to custom panel
1
Insert Ø 3.9 x 1/2" (13mm) screws through the top two
pilot holes. Fix the slider bracket to the panel through
the lower pilot holes.
Increase
Decrease
Balance the door
4
Check the door balance by opening and closing
the door. If the door drops when released,
increase the tension. If the door rises when
released, decrease the tension.
12
!2
ATTACHING CUSTOM DOOR PANEL
Top screw detail
3mm
Hang custom panel onto the door
2
Close the door of the dishwasher and align the screws
and the bracket on the custom panel to the front of the
dishwasher door.
3
Secure the custom panel
5
Open the door and remove the
four screws and replace with
Ø3.9 x 1 1/2" (38mm) screws to
fix the panel into place.
Adust the placement of the custom panel
Slide the custom panel up or down to position it in the
desired location.
Screw locations
(repeat on both side of appliance)
Hide quick links:
Advertisement
Table of Contents
