Table of Contents
Advertisement
Assign the LX II a Device Name
Choose Device Settings > Network to go to the Basic Network
Settings page in the LX II Remote client.
•
Specify a meaningful Device Name for your LX II device.
Up to 32 alphanumeric and valid special characters, no
spaces between characters.
Next, configure the IP address and DNS settings.
Configure the Network: IPv4 and IPv6 Settings
1. Set the IP Auto Configuration to None in the IPv4 section.
2. Enter the IP address you want to use to connect to the LX II
LAN1. The default IP address is 192.168.0.192.
3. Enter the IPv4 Subnet Mask. The default subnet mask is
255.255.255.0.
4. Complete the IPv6 sections, if applicable.
5. Select the IP Auto Configuration. If None is selected, you must
manually specify -
Global/Unique IP Address - this is the IP address assigned to
LX II.
Prefix Length - this is the number of bits used in the IPv6
address.
Gateway IP Address.
Select Router Discovery to locate a Global or Unique IPv6
address instead of a Link-Local subnet. Once located, the
address is automatically applied.
Note that the following additional, read-only information
appears in this section -
Link-Local IP Address - this address is automatically
assigned to the device. It is used for neighbor discovery or
when no routers are present.
Zone ID - Identifies the device the address is associated
with. Read-Only
6. Select "Use the Following DNS Server Addresses" and enter the
Primary DNS Server IP Address and Secondary DNS Server IP
Address. The secondary addresse is used if the primary DNS
server connection is lost due to an outage.
Note: "Obtain DNS Server Address Automatically" and
"Preferred DHCP Host Name" are only enabled when LX II is
configured in DHCP mode
Dominion LX II Quick Setup Guide
QSG-DLX2-v3.0.0-0A-E 255-62-0024-00
7. When finished, click OK. Your LX II device is now accessible via
the LAN IP address.
Name Your Target Servers
1. Connect all of the target servers if you have not already done
so.
2. Select Device Settings > Port Configuration, then click the Port
Name of the target server you want to name.
3. Enter a name for the server. Up to 32 alphanumeric and special
characters. Click OK.
Configure Date/Time Settings
The date and time settings impact SSL certificate validation if LDAPS
is enabled. Configuring the date and time also ensures your audit
logs will be timestamped correctly.
There are two ways to do this:
•
Manually set the date and time.
4
Advertisement
Table of Contents
