Step 5. Verify Operation Of The Network Analyzer Modules; The Operator's Check - Keysight M9485A Startup Manual

Pxie vector network analyzer modules

Hide thumbs Also See for M9485A:

Table of Contents

Getting Started

STEP 5. Verify Operation of the Network Analyzer Modules

Allow the network analyzer modules to warm up for at least 15 minutes before performing

NOTE

the Operator's Check.

The operator check is a self test that checks the basic operation of the

assemblies in all of the measurement port signal paths. This allows you to

confirm the cable connection and modules' basic operations. No tools are

required to execute this test.

Removing the DUT from the test port is recommended.

All the test ports will be short circuited during the test. If the test fails, an error

dialog box is displayed. Click on Help to show the troubleshooting hint in the

help file.

The operator's check is not complete solution to find all malfunctions. Hence,

perform the verification and performance tests to check the complete

performance of M9485A.

Operator's check is executed at the Soft Front Panel boot up default. You can

turn off the start up test by the preference setting (System > System Setting >

Preference...).

Optionally, you can execute the test manually by selecting System > Service >

Operator's Check.

Table of Contents