Eaton 9SX 15KPM Serie User Manual page 64

304 Bus imbalance
308 Bus short
100 Bus soft start failed
805 Output short
822 L1 Output short
823 L2 Output short
824 L3 Output short
70D Inverter voltage high
70C Inverter voltage low
Inverter soft start
704
fault
Inverter overload
705
fault
808 Output overload fault
208 Bypass overload fault
Inverter capacitor
70E
disconnect
010 Main SPS fault
017 Auxiliary SPS fault
806 Emergency shutdown
Internal heat sink
706
temperature high
Bypass temperature
203
high
Charger temperature
501
high
Ambient temperature
004
high
007 Internal fan fault
20E Bypass fan fault
80D Working mode fault
811 Negative power
low
Bus imbalance
Bus short
Bus boost fault
Output short
Inverter voltage high
Inverter voltage low
Inverter startup fault
Load exceeds rated
value
Inverter damage
UPS internal power
supply is abnormal
Shut down in emergency
Internal over
temperature fault
Ambient temperature
high
Fan fault
Working mode setting
error
63
Please contact your supplier
Please contact your supplier
Please contact your supplier
Turn off the UPS, remove all
loads, verify the load is not
fault or short circuit. Press the
button to clear the fault alarm
and restart. If it fails, please
contact your supplier
Please contact your supplier
Redistribute the load, remove
the non-critical load, and check
if the load is fault
Please contact your supplier
Please contact your supplier
Please check EPO terminal
status
Please contact your supplier
Check if the ambient
temperature exceed 50°C. If the
ambient temperature is
normal, the UPS still alarms.
Please contact your supplier
Please contact your supplier
Please contact your supplier
Please contact your supplier