Power Saving Mode Setting Switch; Filter Installation (Option) - Hamamatsu Photonics LIGHTINGCURE LC8 Instruction Manual

■ Power saving mode setting switch
The switch is factory-set to the "Normal"
side.
With the switch set to the "Save" side, you
can save about 10 % of power consump-
tion. However, as this setting also causes
light intensity to reduce, its use is effective when using the
equipment with comparatively low light intensity. Also, the
lamp deterioration with passage of use time becomes less
when this setting is used.
● Setting power saving mode
q Disconnect the power cord and all other cords.
w Remove the cover of the light source unit. (8 M4 screws)
e Set the power saving mode setting switch as desired.
r Install the cover of the light source unit.
Caution
● Be sure to disconnect the power cord before
changing the power saving mode setting.
It is possible to install a specified filter (A9616 series) to a unit of LIGHTING CURE LC8 series.
■ Filter Installation
Caution
● Be sure to disconnect the power cord when installing the filter.
● Do not install the filter while the lamp is lit.
● Make sure wait for 10 minutets or more after the lamp is turned off and check that the unit has been cooled off
before installing the filter.
q Using a screwdriver, loosen fixing screws and remove
the top cover of the unit.
w Install the filter to the cover.
* Use the guide mark for installation of the filter
on the back (unpainted) of the cover. The filter
installed in the reverse direction here cannot be
inserted in the light source unit.
q, r
M3 screw

Filter Installation (Option)

w
2 M3 flat head screws used here
Stamp
L9566 series
L9588 series
e Insert the filter into the light source unit.
r Fix the cover by tightening its screws.
Stamp
26
Save Normal
POWER SAVING
Save Normal
POWER SAVING
e