Overland Storage SnapServer DX1 Add-On Instructions page 4

Add-on/Spare DIMM Instructions
Install Drives
1. Position a drive assembly in front of an empty slot.
2. Slide the assembly in until the latch clicks, locking it in
the slot.
3. Repeat
Steps 1–2 for all remaining drive carriers.
IMPORTANT: To maintain proper airflow and cooling, a drive
assembly or a blank carrier must be installed in every slot. No
empty slots are allowed.
Attach the Bezel
1. Position the bezel with the top edge tabs aligned with the
top slots located on the front of the appliance.
2. Move the bezel toward the appliance until the magnets
make contact.
3. Verify that the bezel is aligned properly and that all the
LEDs are visible.
Attach Cables and Power Cords
1. Reattach all the cables (except power cords) to the same
connections previously used.
2. Attach the power cord.
3. At the front, press the power switch to power it on.
Return Old Part to Overland
1. Place the old part in the anti-static bag and put it in the
replacement part's box.
2. Use an RMA to return the part to Overland Storage.
For return shipping details and RMA number, go to:
http://docs.overlandstorage.com/return-instructions
http://support.overlandstorage.com
You can get additional technical support on the Internet at the
the information found on the
10400351-002 02/2013
Overland Storage Support web
Contact Us page on our web site.
©2011-13 Overland Storage, Inc.
Magnets
Data Cables
page, or by contacting Overland Storage using
Top Tab
Power Socket
Page 4 of 4
