Adjusting The Anti-Scalp Rollers; After Operation; After Operation Safety; Using The Fuel-Shutoff Valve - Toro ProLine 44410TE Operator's Manual

Adjusting the Anti-Scalp
Rollers
Models with a 122 cm (48 inch)
Deck Only
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the nut and bolt position the anti-scalp
rollers and install the nut and bolt.
4. Ensure that the spacers and bushings are
installed (Figure
Figure 19
1. Bushing
2. Anti-scalp roller
3. Spacer
19).
4. Bolt
5. Nut

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, remove the ignition
key (if equipped), wait for all moving parts to stop,
and allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Direct both front and rear
straps down and outward from the machine.
Using the Fuel-Shutoff
Valve
Close the fuel-shutoff valve for transport, maintenance,
and storage (Figure
Ensure that the fuel-shutoff valve is open when
starting the engine.
g301976
1. O position
FF
19
20).
Figure 20
2. O position
N
g299483