Toro ProLine 44410TE Operator's Manual page 21

Figure 22
1. Full-width ramp in stowed
position
2. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
Loading the Machine
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and walk it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes and
lights.
3. Lower the ramp (Figure
4. Back the machine up the ramp
g229507
3. H=height of the trailer or
truck bed to the ground
4. Trailer
22).
(Figure 23).
1. Back the machine up the
ramp.
5. Shut off the engine, remove the key, and engage
the parking brake.
6. Tie down the machine near the front caster
wheels and the rear bumper with straps, chains,
cable, or ropes
regulations for tie-down requirements.
1. Tie-down loops
21
Figure 23
2. Walk the machine down
the ramp.
(Figure 24). Refer to local
Figure 24
g299488
g303828