Toro ProLine 44410TE Operator's Manual page 41

Figure 57
1. Clutch pulley
2. Washer
6. Insert a drive ratchet in the square hole of the
idler arm to release the belt tension
Figure 58
1. Spring
2. Idler pulley
7. Remove the belt (Figure
8. Slowly release the driver to release the spring
tension. Remove the spring from the anchor on
the frame, if needed.
9. Install the new belt, routing it around the pulleys
as shown in Figure
3. Bolt
(Figure
3. Square hole
59).
59.
1. Belt
g300383
10. Install the spring to the spring anchor. Use the
drive ratchet to apply tension to the spring to
allow the belt to pass over the lip of the idler
pulley (Figure
11. Release the tension in the spring to apply
tension to the belt.
58).
12. Check that the belt is seated properly in all the
pulleys.
13. Install the clutch pulley
bolt to 68 to 81 N∙m (50 to 60 ft-lb).
14. Install the guard plate
15. Install the mower-deck belt to the clutch pulley;
refer to Replacing the Mower-Deck Belt (page
39).
g308541
41
Figure 59
2. Idler pulley
58).
(Figure 57). Torque the
(Figure 57).
g300384