Driving The Machine - Toro ProLine 44410TE Operator's Manual

Driving the Machine

The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance.
Note:
The engine shuts off if you move the
motion-control levers while the parking brake is
engaged or if the machine idles for 5 seconds while
the parking brake is disengaged.
CAUTION
The machine can spin very rapidly, and you
may lose control of the machine, causing
personal injury to you and damage to the
machine.
Slow down the machine before making sharp
turns.
Driving Forward
1. Disengage the parking brake; refer to
the Parking Brake (page
2. Move the motion-control levers down to the
N position.
EUTRAL
Figure 14
1. Front reference bar
2. Left control lever in
N position
EUTRAL
3. Rear reference bar
3. Slowly push the motion-control levers forward
(Figure 15).
position for best
AST
Operating
13).
4. Right control lever in
N position
EUTRAL
5. Right control lever when
released
6. Left control lever when
released
Note:
The farther you move the motion-control
levers in either direction, the faster the machine
moves in that direction.
Note:
To stop, move the motion-control levers
back to the N
Driving Backward
1. Move both motion-control levers to the N
position.
2. Slowly pull the motion-control levers rearward
(Figure 16).
g299431
16
position.
EUTRAL
Figure 15
Figure 16
g303736
EUTRAL
g303735