Cleaning; Cleaning Under The Mower; Disposing Of Waste - Toro ProLine 44410TE Operator's Manual

3. Position the new discharge deflector with the
bracket ends between the welded brackets on
the deck as shown in
4. Install the spring onto the straight end of the rod.
5. Position the spring on the rod as shown in
79 so that the shorter spring end comes from
under the rod before the bend and going over
the rod as it returns from the bend.
6. Lift the loop end of the spring and place it into
the notch on the deflector bracket
Figure 79
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
7. Secure the rod and spring assembly by twisting
it so that the short end of the rod is behind the
mower bracket welded to the deck
Important:
The grass deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
Figure 79.
Figure
(Figure 79).
g297573
3. Rod, short end, moved
behind the mower bracket
4. Short end, retained by
mower bracket.
(Figure 79).

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3. Raise the front of the machine using a jack and
use jack stands to support the machine.
4. Clean the machine with a rag. Do not spray the
machine.

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
51