Toro ProLine 44410TE Operator's Manual page 49

1. Measure from a level
surface
3. The difference between measurements B and C
should be no more than 6 mm (1/4 inch).
Note:
If it is not correct, refer to
Mower Deck (page
Checking the Mower Deck
Front-to-Rear Pitch
1. Adjust the tire pressure in the rear tires to the
correct specifications.
2. Position 1 blade front-to-rear. Measure at A and
B locations from a level surface to the cutting
edge of the blade tips
Note:
The mower blade should be 6 mm (1/4
inch) lower in front at A than in the rear at B.
3. Rotate the blades and repeat for other blades.
1. Measure the blade at
points A and B
Figure 74
2. Measure the blade at
points B and C
Leveling the
49).
(Figure 75).
Figure 75
2. Measure from a level
surface
4. If the front-to-rear pitch is not correct, refer to
Leveling the Mower Deck (page
Leveling the Mower Deck
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page 18)
4. Place 2 blocks, each having a thickness of 6.6
g006888
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets
5. Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (Figure
122 cm (48-inch) Deck Shown
1. Wood block—6.6 cm
(2-5/8 inches) thick
2. Wood block—7.3 cm
(2-7/8 inches) thick
6. Loosen the adjustment bolts on all 4 corners
of the deck so that the deck is sitting on all 4
blocks.
g001041
49
48).
Adjusting the Height of Cut
(Figure 76).
76).
Figure 76
3. Front edge
g303116