Inspect After Operating; Submerged Outboard Motor - Honda BF200D Manual

42ZVL600.book 135 ページ ２０１８年７月１９日 木曜日 午前９時６分

Inspect After Operating

1. Stop the engine and remove the
engine cover (see page 57).
2. Confirm the cooling water leakage
from the engine.

Submerged Outboard Motor

A submerged outboard motor must be
serviced immediately after it is
recovered from the water in order to
minimize corrosion.
If there is a Honda outboard motor
dealership nearby, take the outboard
motor immediately to the dealer. If
you are far from a dealership, proceed
as follows:
1. Remove the engine cover (see page
57), and rinse the outboard motor
with fresh water to remove salt
water, sand, mud, etc.
If the outboard motor was running
when it submerged, there may be
mechanical damage, such as bent
connecting rods. If the engine binds
when cranked, do not attempt to
run the outboard motor until it has
been repaired.
MAINTENANCE
2. Change the engine oil (see page
118).
3. Remove the spark plugs (see page
120). Operate the starter to expel
water from the engine's cylinder.
4. Put a teaspoon of engine oil into
each spark plug hole to lubricate
the inside of the cylinders.
Reinstall the spark plugs.
5. Install the engine cover and lock
the latch securely (see page 57).
135