Honda BF200D Manual page 122

42ZVL600.book 122 ページ ２０１８年７月１９日 木曜日 午前９時６分
MAINTENANCE
SIDE ELECTRODE
1.0 – 1.1 mm
(0.039 – 0.043 in)
WASHER
INSULATOR
7. Measure the plug gaps with a feeler
gauge. Correct the gap, if
necessary, by carefully bending the
side electrode.
The gaps should be: 1.0 – 1.1 mm
(0.039 – 0.043 in)
8. Thread the plugs in by hand to
prevent cross threading.
9. After the spark plugs are seated,
tighten with a spark plug wrench to
compress the washers.
TIGHTENING TORQUE:
18 N·m (1.8 kgf·m , 13 lbf·ft)
122
If installing new spark plugs, tighten
1/2 turn after the spark plug seats to
compress the washers.
If reinstalling used spark plugs,
tighten 1/8 – 1/4 turn after the spark
plug seats to compress the washers.
The spark plugs must be securely
tightened. An improperly tightened
plug can become very hot and may
cause engine damage.
10. Install the ignition coil. Reinstall
the bolt.
11. Push the wire connector onto the
ignition coil. Make sure it locks in
place.
12. Repeat this procedure for the
other five spark plugs.
13. Reinstall the engine cover.