Rcom MARU DELUXE PRO Series User Manual page 8

USA & Canada Official Sales & Service https://www.R-Com-Hatcher.com
2. Before use
What is an Incubation Room?
The Incubation Room is a confined space for setting and operating an incubator efficiently.
An Incubation Room environment has a considerable effect on hatch rate. Controlling the incubator
environment is recommended; there should be little noise or vibration and constant temperature ranging
upwards from 28℃(82.4℉) with small variation in temperature. For optimum performance, pay attention
that your incubator isn't exposed to temperature drops compared with daytime. Do not directly exposed the
incubator to sunlight during daytime. also, please incubator where direct wind from air-conditioner not to reach.
If you set a high temperature, condensation will occur and may causes water to leak from the incubator and
it which is not a technical problem. You need to keep temperature between 28
How to Install this Incubator
▶ Please set the incubator horizontally on a stable, tallish
table (50[cm] or above)
▶ Ensure the incubator is completely level, so the door can
close completely.
▶ Connect silicon tubing onto the nipple of incubator, and
the other end of silicon tubing into a water container.
Do not place water container on top
of the incubator. It may flood the
humidity unit.
Using tap water or underground water
instead of distilled water in this unit's
humidification device will cause serious
debris (scale) to develop. In this case,
the inconvenience of frequent cleaning
will occur and when left alone, may
become the cause of malfunction or
breakage. If you have any questions
regarding such problems, please contact
the place of purchase and failure of the device
due to the consumer negligence (due to non-cleaning), even if it occurred with in the free A/S period,
repair charges might occur when repairing , so use of distilled water is highly recommended.
[ Rotary wheel assembly method ]
Sold Separately
Pieces : 18EA
▶ ⓐ : the front - brake-type wheel x 2
ⓑ : the rear - brake free-type wheel x 2
▶ Cautiously, lay the machine down :
bracket-wheel-screw in sequence
ⓐ for the front 2wheels, assemble brake-type wheel
ⓑ for the rear 2wheels, assemble brake free-type wheel
Once the assembly done, put up the assembled incubator
with care.
The device can be broken or injured due to weight when setting up or laying down the machine, so remove
the egg basket or trays inside the device before assembling.
8
Egg Incubator Hatcher Maru Pro User Manual
- Rotary wheels are sold separately
(2EA) (2EA) (Bracket 4EA)
(1) What is an Incubation Room?
(2) How to install this Incubator /
Preparing for Incubation
50cm
WATER IN
℃ (82.4 ℉ ).
DIGITAL INCUBATOR