Table of Contents
Advertisement
INDEX
1. PRODUCT DESCRIPTION
2. INSTALLATION
2.1 Mounting the product
2.2 Mounting the wireless safety system (BST24/BST25/BST25S)
2.3 Control unit diagram
2.4 Electrical connections
2.5 Wired safety device connections
3. PRELIMINARY CHECK AND INITIAL START-UP
3.1 Limit switches configuration
3.2 Deactivation of wireless safety system
3.3 Exclusion of safety edge in the last 5cm of the closure
4. TRANSMITTERS MEMORIZATION
4.1 Single channel memorization
4.2 Double channel memorization
4.3 Single channel: Courtesy light ON/OFF
4.4 Four channels memorization
4.5 Remote memorization of the first transmitter
4.6 Remote memorization of further transmitters
4.7 Alarm function: shock sensor memorization
4.8 Single channel: door status request ("ASK")
5. TRANSMITTERS DELETION
5.1 Deleting a single transmitter
5.2 Deleting all the transmitters
5.3 Remote deletion of a transmitter
6. TIME SETTINGS
6.1 Auto close time setting
6.2 Courtesy light time setting
7. OTHER PROGRAMMING
7.1 "Holiday mode"
8. TECHNICAL SPECIFICATIONS
8.1 WARNINGS
9. TROUBLESHOOTING (What to do if...)
--------------------------------------------------------------- p. 3
----------------------------------------------------------------------- p. 4 - 8
-------------------------------------------------------- p. 12 - 14
-------------------------------------------------------- p. 15
----------------------------------------------------------------------- p. 16
--------------------------------------------------------------- p. 17
------------------------------------------------------ p. 18
----------------------------------------------- p. 19 - 20
--------------------------------------- p. 9 - 11
2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TVRPS868E01 and is the answer not in the manual?
Questions and answers
Door opens no problem, door will not close, have to wind it down manually.
The TELECO AUTOMATION TVRPS868E01 door may open but not close automatically due to the safety edge being activated or defective. If the floor is uneven, the safety edge can be deactivated using procedure 3.2 in the last part of the closure. Additionally, for the closure to be effective, the command must start from the upper limit switch. If safety devices (except for TB input) are defective or activated, the door can still be operated by holding the command button for more than 5 seconds, switching the control unit to hold-to-run mode.
This answer is automatically generated