Table of Contents
Advertisement
4. Transmitter memorization
This operation should be done using the button P1. Please refer to the schematic diagram on page 7 in order
to localize the position on the board.
4.1 Single channel memorization
Memorization of a single button of any transmitter,
with function OPEN - STOP - CLOSE
keep it pressed
(
)
P1
continuous sound
4.2 Double channel memorization
Memorization of two buttons of any transmitter in one
step, with function OPEN (STOP) - CLOSE (STOP)
keep it pressed
(
)
2x
P1
continuous sound
4.3 Single channel: courtesy light ON/OFF
Memorization of a single button of any transmitter,
with function LIGHT ON - LIGHT OFF
(
3x
P1
continuous sound
button to
memorize
...
intermittent sound
button to
memorize
intermittent sound
keep it pressed
)
button to
memorize
intermittent sound
OPEN - STOP - CLOSE ►
Press P1 once and keep it pressed.
The buzzer emits a continuous sound.
Press any button to memorize.
Once the memorization is successfully completed,
the buzzer emits a fast intermittent sound.
Press P1 twice and keep it pressed.
The buzzer emits a continuous sound.
Press any button of the pair to memorize.
Once the memorization is successfully completed,
...
the buzzer emits a fast intermittent sound.
LIGHT ON - LIGHT OFF ►
Press P1 three times and keep it pressed.
The buzzer emits a continuous sound.
Press any button of the pair to memorize.
Once the memorization is successfully completed,
...
the buzzer emits a fast intermittent sound.
12
OPEN (STOP) ►
CLOSE (STOP) ►
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TVRPS868E01 and is the answer not in the manual?
Questions and answers
Door opens no problem, door will not close, have to wind it down manually.
The TELECO AUTOMATION TVRPS868E01 door may open but not close automatically due to the safety edge being activated or defective. If the floor is uneven, the safety edge can be deactivated using procedure 3.2 in the last part of the closure. Additionally, for the closure to be effective, the command must start from the upper limit switch. If safety devices (except for TB input) are defective or activated, the door can still be operated by holding the command button for more than 5 seconds, switching the control unit to hold-to-run mode.
This answer is automatically generated