Zebra Printer Format File Selection; Radio Parameters; Radio Protocol Timeout; Transmission Retry - Datalogic GRYPHON BT Reference Manual

Table of Contents

REFERENCES

Setting between 1 and 4 parameters allows printing barcode labels with barcode

and/or code ID information. The number of barcode/code ID values selected must

match the number of printer parameters selected.

The Gryphon™ BT default setting is:

where Gryphon™ BT sends two parameters (both barcode data) to file 00. The

assumption is that one barcode is used to print the actual barcode and the other is

used to print the human readable numbers of the barcode all on the same label.

Not all barcode symbologies read by Gryphon™ BT are managed by the printer, see

your printer documentation for a list of printable barcode symbologies.

5.4.2

Zebra Printer Format File Selection

Select the number of the Zebra printer format file which is pre-loaded in the printer

memory and contains the graphic and parameter value information for printing a

label. These files must be programmed correctly to accept the data passed to them

from the Gryphon™ BT reader.

5.5

5.5.1

This parameter sets the valid time to wait before transmission between the

Gryphon™ BT reader and the remote Bluetooth

This parameter should be set taking into consideration the radio traffic (number of

readers in the same area). It can be set between 3 and 19 seconds.

5.5.2

This parameter allows setting a period of time in which transmission of the previously

read barcode will automatically be retried. If not disabled (00), this value must be at

least equal to double the Radio Protocol Timeout value (see par. 5.5.1).

Each time transmission is retried, the reader emits the transmission beep, if enabled

(see par. 5.5.6).

Transmission retry is valid only if ACK/NACK Protocol is enabled (see par. 5.5.3).

"! UF DLFMT00.FMT barcoderead barcoderead"

device is considered failed.

Table of Contents