Edge-Core ECIS4500 Series Quick Installation Manual page 12

CLI Initialization and Configuration (Optional)
1. Connecting to the Ethernet port (RJ-45 Ethernet port) of managed switch
2. Key-in the command under Telnet: telnet 192.168.2.10
3. Login with default account and password.
4. Username: admin;
Password: admin
Change the IP with commands listed below:
CLI Command:
enable
configure terminal
interface vlan 1
ip address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
exit
LED STATUS INDICATIONS
LED Indicator /color
P1/P2
Alarm
Copper port Link/Act
Copper port Speed
SFP port Link/Act
SFP port Speed
PoE LED
Condition
On Green P1/P2 power line has power
Off P1/P2 power line disconnect or does not have power
On Red Ethernet link fails, alarm or power failure alarm occurs
Off No Ethernet link fails and no power failure alarm
On Green Ethernet link up but no traffic is detected
Flashing Green Ethernet link up and there is traffic detected
Off Ethernet link down
On Yellow A 1000 Mbps connection is detected
Off No link, a 10 Mbps or 100 Mbps connection is detected
On Green Ethernet link up
Off Ethernet link down
On Yellow SFP port speed 1000 Mbps connection is detected.
Off No link or a SFP port speed 100 Mbps connection is
On Yellow PoE is detected
Off No link
12
ECIS4500 Quick Installation Guide