Noise And Vibration - Flex X 1107 VE Original Operating Instructions

 When working, hold the electric power
tool firmly with both hands and ensure
that you have a secure footing.
The electric power tool is controlled more
securely if held with both hands.
 Secure the workpiece.
A workpiece is held more securely in
a clamping device or vice than by hand.
 Keep the workplace clean.
Material mixtures are especially dangerous.
Light metal dust may burn or explode.
 Do not use the electric power tool
if it has a damaged power cord.
Do not touch the damaged power cord
and pull out the mains plug if the power
cord is damaged during work.
Damaged power cords increase the risk
of an electric shock.
 Never grind or cut light metals which have
a magnesium content greater than 80%.
Risk of fire!
 Before using the machine, check that
the grinding tools have been installed and
secured correctly. Switch on the machine
at no load for 30 seconds! Interrupt the test
run immediately if violent vibrations occur
or other damage is established.
Check the machine to determine
the cause.
 Before putting down the power tool, switch
it off and wait until it comes to a standstill.
 Do not clamp the power tool in a vice.
 Always lay the power cord to the rear away
from the electric power tool.
Additional safety instructions
 Use only extension cables permitted
for outdoor use.
 Identify the power tool with stickers only.
Do not drill any holes into the housing.
 The mains voltage and the voltage
specifications on the rating plate must
correspond.
12

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool is
typically:
– Sound pressure level:
– Sound power level:
– Uncertainty:
Total vibration value:
– Emission value:
– Uncertainty
t^okfkd>
qÜÉ=áåÇáÅ~íÉÇ=ãÉ~ëìêÉãÉåíë=êÉÑÉê=íç=åÉï=
éçïÉê=íççäëK=a~áäó=ìëÉ=Å~ìëÉë=íÜÉ=åçáëÉ=~åÇ=
îáÄê~íáçå=î~äìÉë=íç=ÅÜ~åÖÉK
klqb
The vibration emission level given in this infor-
mation sheet has been measured in accor-
dance with a standardised test given in
EN 60745 and may be used to compare
one tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications
of the tool. However if the tool is used for
different applications, with different acces-
sories or poorly maintained, the vibration
emission may differ. This may significantly
increase the exposure level over the total
working period.
For a precise estimation of the vibration load the
times should also be considered during which
the power tool is switched off or even running,
but not actually in use. This may significantly
decrease the exposure level over the total
working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
`^rqflk>
tÉ~ê=É~ê=éêçíÉÅíáçå=~í=~=ëçìåÇ=éêÉëëìêÉ=
~ÄçîÉ=UR=Ç_E^FK
X 1107 VE
88 dB(A)
99 dB(A)
K = 3 dB
2
a = 7.2 m/s
h
2
K = 1.5 m/s