The 32003 Insertion/Extraction Valve; The 33095 Sensor Housing; Tuchenhagen Varivent® In-Line Access Unit - Hach ORBISPHERE 51 Series User Manual

3.8.7

The 32003 insertion/extraction valve

The ORBISPHERE 32003 insertion/extraction valve (illustrated below) allows for sensor
removal and installation without having to drain the fluid in the line. It can withstand a pressure
of up to 20 bars, with the sensor in place or not.
Sensor insertion is made by inserting the sensor into the housing and tightening the retaining
collar until it stops. As the retaining collar is tightened, the valve will open to allow the sample to
flow past the sensor head. Remove the sensor by unscrewing the collar and pulling the sensor
out. As the collar is unscrewed, the valve will automatically close to avoid any sample spillage.
The diagram above right, shows the sensor in a sample line with the valve open.
3.8.8

The 33095 sensor housing

Another type of sensor housing (the ORBISPHERE 33095 housing) is available for use with the
K1200 sensor but requires that the sample flow be turned off prior to insertion or removal of the
sensor.
Sensor insertion is made by inserting the sensor into the housing and tightening the retaining
collar until it stops. Removal is made by unscrewing the collar and pulling the sensor out. Be
sure that the sample flow has been turned off before inserting or removing the sensor.
3.8.9 Tuchenhagen Varivent® in-line access unit
The following illustration shows the Tuchenhagen Varivent® In-Line Access Unit.
Purchasing a Tuchenhagen Varivent® in-line access unit, or an equivalent fitting with a 68 mm
flange diameter from the fitting manufacturer, is required to make use of the ORBISPHERE
model 32003 or 33095 sensor housing devices detailed above.
Figure 21 ORBISPHERE model 32003 insertion/extraction valve
Figure 22 Tuchenhagen Varivent® in-line access unit
Installation
37